Scratch and etch mark remover for use with marble, travertine and limestone. Leaves a non-shiny, non-reflective and even finish to the stone. Safe and easy to use, doesn’t contain acids. To use this MP abrasive honing powder we advise you use on a wet surface with a rust-free wire wool pad.
Instructions for use:
Apply to the surface of the stone, using roughly two handfuls of the honing powder at a time to build a pile. Create a well in the middle of the powder, and pour approximately 50ml of water in, or enough to dampen the honing powder. Hold your polisher directly above the powder, then switch on and bring down to begin polishing. Apply more water during polishing to ensure the surface is kept damp.
£43.06
In Stock
Scratch and etch mark remover for use with marble, travertine and limestone. Leaves a non-shiny, non-reflective and even finish to the stone. Safe and easy to use, doesn’t contain acids. To use this MP abrasive honing powder we advise you use on a wet surface with a rust-free wire wool pad.
Instructions for use:
Apply to the surface of the stone, using roughly two handfuls of the honing powder at a time to build a pile. Create a well in the middle of the powder, and pour approximately 50ml of water in, or enough to dampen the honing powder. Hold your polisher directly above the powder, then switch on and bring down to begin polishing. Apply more water during polishing to ensure the surface is kept damp.
No technical downloads available.
